Paper Keytar Update

 This is the small mock-up version that I started a few weeks ago

This photo shows the reinforcements added to the inside of the back portion. I chose to make them curved like this so that they would still have flexibility if they needed to be pressed over to the side to make room for the keyboard portion, but still provide support due to the curved shapes.

Inside of front portion.

This is the underside of the keyboard portion, showing the overlapped triangular supports.

Unfinished keyboard, just needing to design the "black keys", using Rhino, and then have them laser cut.

The body, just needing the additional buttons and knobs, which will also be designed and cut digitally.

I think I may have subconsciously lifted the design for this from this knife, haha. But there do seem to be some similarities.